About

Read points are powerful RFID sensors that can be mounted almost anywhere to track RFID tags passing through the sensors range. The most common configurations include doorway-mounted portals that track the movement of tags in and out of the room, and ceiling or wall-mounted portals that track the sighting of tags in a particular location.

Model: TS090

Commands

ConfigParameters

NameDescriptionData TypeMinMaxDefault
AntennaTxPowerThe dB transmit power of all of the antennas.Int153223
AntennaRxSensitivityThe dB receive sensitivity of all of the antennas.Int-80-30-70
AutoUpdateFirmware auto update enable.Bool010
CaptureTimeTime in seconds before a tag that enters the field is reported.Int11205
CommandPollIntervalThe number of minutes between polling for device commands in Jetstream.Int060060
CommsRebootNumber of minutes after the system loses communication that it will automatically reboot.Int101440230
CommsReconnectIntervalTime in seconds to wait before attempting to communicate with Jetstream if there were any communication problems.Int130010
CommsTimeoutTime in seconds to wait for a reply from Jetstream after sending an event or command response.Int130060
HeartbeatEventIntervalThe number of minutes between sending a HeartbeatEvent. A setting of 0 will disable HeartbeatEvents.Int060060
InactivityIntervalTime in seconds communications will wait before re-establishing a connection if there is no activity.Int03600300
JetstreamDeviceUrlThe URL to which the read point sends Jetstream messages.String--us-device.tersosolutions.com
JetstreamWebsocketAppEndpointThe Jetstream resource used to connect for WebSocket communications. Using '#' will disable WebSocket communications.String--/dwsliveconnection.ashx
LogEntryLevelThe verbosity of the logs sent by the reader
  • Off
  • Error
  • Warning
  • Information
  • Verbose
String--Error
LogFileLevelThe verbosity of the logs saved locally on the reader
  • Off
  • Error
  • Warning
  • Information
  • Verbose
  • Trace
  • Debug
String--Debug
NumAntennasNumber of antennas active for reader.Int141
ObjectEventHourThe hour to perform the daily system scan as well as other system checks. A value of -1 disables this feature.Int-1230
ReaderLogEntryOnFailureGenerate a LogEntryEvent when communications to the internal RFID reader fails.Bool010
RemoveEventSets whether an aggregate event "remove" is sent when a tag leaves the field of scanning.Bool010
SecureSocketUse secure communications over HTTPS for the read point.Bool011
VersionsFileUrlLocation of file listing current versions of firmware. Used to configure auto firmware update.String--http://firmware.tersosolutions.com/versions.json

LogEntryEvents

The list below are some common, potential LogEntryEvents a read point may send in. However, not all possible LogEntryEvents are listed in this table. The LogEntryLevel in use determines which LogEntryEvents are sent to Jetstream.

NameDescription
LowFlashMemoryLowFlashMemory occurs when the read point has less than 25% flash memory.
LowMemoryLowMemory occurs when the read point has less than 25% memory. This event will be sent every hour until the device reboots. Reboot occurs automatically if memory drops to 10%.
NewFirmwareDownloadErrorNewFirmwareDownloadError occurs when a request to upgrade firmware fails.
ReadExceptionReadException occurs when there is an issue performing an RFID scan.
StartupStartup occurs whenever the read point is started up.


SensorReadingEvents

The Read Point does not generate any SensorReadingEvents.