20240717 Enclosure FW v5.2.37 / OS 11.7.12.2 Release

enclosure firmware version 5 2 37 release notes release dates production go live july 17, 2024 field, auto update go live july 17, 2024 platforms iris, iris quad affected models this firmware (fw) update affects the following enclosure models with an iris or iris quad sbcs that are currently running fw v5 x ts030 large rfid cabinet ts032 compact rfid cabinet ts035 compact rfid cabinet (europe) ts047e – compact rfid freezer (europe) ts056 – large rfid cabinet (europe) ts060 – compact rfid refrigerator (europe) ts074e large rfid refrigerator ts088 ultra low temperature rfid freezer ts092 large secure access cabinet ts093 midsize rfid freezer ts096 undercounter rfid freezer ts097 undercounter rfid refrigerator ts098 countertop rfid refrigerator ts099 midsize rfid refrigerator ts105 – countertop rfid freezer (europe) ts107 – room temperature stability cabinet firmware version fw v5 2 37 / os 11 7 12 2 application production fw v5 2 37 should be installed on all new production enclosure models with iris or iris quad sbcs field fw v5 2 37 should be installed on all field installed models with iris or iris quad sbcs that are currently running v5 0 xx overview of changes this update is a minor version update to iris firmware version 5 2 this version includes improvements to memory leakage, addition of support for multiple new temperature measurement hardware sources, and important bug fixes relating to lcd messaging, reboots, and firmware commands adds new temperature measurement sources support this version of the firmware now supports three potential temperature measurement sources (the original i2c, ereshop board i2c version, and spi) removes none changes ts092 secure access cabinet door open/close incorrect lcd message the incorrect lcd message (system scanning) would be displayed on the ts092 after the door was closed this has been resolved with the correct lcd message (scan pass) appearing once the door has been closed first time sync certificate validation when performing a time sync for the first time certificate validation is no longer required memory leakage addressed consecutive display message triggering reboot it has been seen that excessive writes to the display triggers the firmware to reboot this has been resolved in this firmware version setconfigvalues command only returns maximum of 10 invalid parameters the setconfigvalues command would only return maximum of 10 invalid parameters the firmware has been updated to allocate the same number of invalid parameters device definitions current device definitions for the previous version are still valid it is recommended that customers use the most current device definitions available unless instructed otherwise by the terso customer success team fw v5 2 xxx, ambient cabinet fw v5 2 xxx, non rfid cabinet fw v5 2 xxx, standard refrigerator fw v5 2 xxx, standard freezer fw v5 2 xxx, ult fw v5 2 xxx, ts105 freezer